Separate names with a comma.
I found it in my local bookstore :-)
I plan to test printing Taulman Bridge filament on this surface, but I have to solve a problem i have when printing Taulman Bridge using my E3D-V5...
Printed this on glass + Puzzle Conserver 65c on the bed - worked fine, and simple to remove when the print bed was could.
When I was in the store to buy UHU glue, then I found something called Puzzle conserver: http://www.babylonpuzzles.com/en/6877-1 ... urger.html I...
I did order what I need to convert my E3D-V5 bowden to direct, and want to test a dual extruder config using 2 x Bulldog Lite extruders + 2 x...
I guess the only gain using bowden is lower weight + maybe better speed? My focus is to get the best possible quality, and I`m willing to wait...
Re: An alternative to Kapton tape when mounting the thermist I did not take any pictures while mounting the thermistor, and I do not have an...
Hi all, I have an Ord Bot Hadron printer with Bulldog Lite Extruder and E3D-V5 1.75mm direct drive hot end. From the start I planned to set up a...
I have been using the Permatex Ultra Copper Silicone with great results. http://www.permatex.com/products-2/prod ... ker-detail Temperature range...
