Recent Content by Ohm

  1. Ohm
    Post

    Extruder motor screeching

    After adding some adjustable springs to my print bed (reused some AA battery holder springs), leveling it manually, and forgoing automated bed...
    Post by: Ohm, Jan 23, 2017 in forum: Titan
  2. Ohm
    Post

    Extruder motor screeching

    Changing the values above did nothing to help - but migrating my settings over to the latest Marlin firmware did in fact solve my problem....
    Post by: Ohm, Jan 21, 2017 in forum: Titan
  3. Ohm
    Post

    Extruder motor screeching

    I'm using Marlin firmware, but it's an older version that was recommended with the printer I bought from FolgerTech. They posted their version at...
    Post by: Ohm, Jan 20, 2017 in forum: Titan
  4. Ohm
    Post

    Extruder motor screeching

    So when I made my original post, I had missed the . in front of the .5v vref statement. I in fact have it set to .5v. I believe that's where my...
    Post by: Ohm, Jan 19, 2017 in forum: Titan
  5. Ohm
    Post

    Extruder motor screeching

    Thanks for all the helpful feedback. I'm quite new to this. Based on what I've read, my previous stepper would have been a 1.8 degree motor, and...
    Post by: Ohm, Jan 18, 2017 in forum: Titan
  6. Ohm
    Thread

    Extruder motor screeching

    I put in a Titan extruder with a Nema17 40N - DShaft .9 deg/step supplied by Maker Farm. I'm using a basic RAMPS 1.4 board with A4988 stepper...
    Thread by: Ohm, Jan 17, 2017, 11 replies, in forum: Titan