Separate names with a comma.
Hello all sometimes i just want to get the nozzle a little more near the bed for the first layer. Always did a complete new bed leveling process...
This is the last one i printed, was already getting difficult to photo the issues. Also attached the stl.
Would be great if you could check your settings. Got quite a improvement already. But unsure how far i can go with those settings and which are...
On the right picture is the first one with speed of 50mm/s and the new one on the left is with 30mm/s. There is really already a improvement. Is...
Here are the pictures. Just now is a print running with slower printing speed, but as i remember correctly that was always identical. Found...
Hi all Any tips here to solve ghosting issues on the bigbox ? I do have the 1.1 with single direct extruder. Cheers
Hi all just changed my Y and X drivers to the 8825 ones. Changing the steps for the Y was something i didn't understand really, it was...
Same here, since i have the voltage down as well, i have no z issues anymore.
There usually is a poti near the connector side of the PSU. I have the same issues but they mostly only showed them self in the MBL FW, maybe...
Just red your findings, that's quite interesting. I am gonna check that, i also increased the voltage lately for the Z, maybe that's the culprit.
Jason, i had the same issues i think as you do with that MBL FW from Alex. It just started, after a few perfect layers in, to print too low into...
Thanks a lot that helped. Checked the gcode for M106 and there was none. Simplify was the culprit, somehow it switched the firmware configuration...
