Recent Content by Olle Wreede

  1. Olle Wreede
    Post

    Adding G10 Temperature Support to PrusaSlicer

    Yes, ooze prevention was enabled. If I disable it, the value does not change the initial layer temp. Setting G10 in the start gcode seems to work...
    Post by: Olle Wreede, Oct 27, 2020 in forum: Getting Started
  2. Olle Wreede
    Post

    Adding G10 Temperature Support to PrusaSlicer

    Tried it out a bit more, it turns out it sets the initial layer temp with ooze prevention subtracted. Which I assume is by design. But it isn't...
    Post by: Olle Wreede, Oct 27, 2020 in forum: Getting Started
  3. Olle Wreede
    Post

    Adding G10 Temperature Support to PrusaSlicer

    I just tried it out and it seems to work. Great job! It seems to add two G10 commands at the start though, one just before the custom start...
    Post by: Olle Wreede, Oct 26, 2020 in forum: Getting Started
  4. Olle Wreede
    Post

    Adding G10 Temperature Support to PrusaSlicer

    Thank you! Will check it out.
    Post by: Olle Wreede, Oct 25, 2020 in forum: Getting Started
  5. Olle Wreede
    Post

    Adding G10 Temperature Support to PrusaSlicer

    Great work! Much appreciated.
    Post by: Olle Wreede, Jul 20, 2020 in forum: Getting Started
  6. Olle Wreede
    Profile Post

    Finally installed the last tool.

    Finally installed the last tool.
    Status Update by Olle Wreede, May 12, 2020
  7. Olle Wreede
    Profile Post

    Setting up some leds on the tool changer

    Setting up some leds on the tool changer
    Status Update by Olle Wreede, May 6, 2020
  8. Olle Wreede
    Profile Post

    Designing a gopro extrusion mount for my webcam

    Designing a gopro extrusion mount for my webcam
    Status Update by Olle Wreede, Apr 13, 2020
  9. Olle Wreede
    Profile Post

    Designing Raspberry Pi extrusion mount for the toolchanger.

    Designing Raspberry Pi extrusion mount for the toolchanger.
    Status Update by Olle Wreede, Apr 11, 2020
  10. Olle Wreede
    Profile Post

    Printing face shields

    Printing face shields
    Status Update by Olle Wreede, Mar 29, 2020
  11. Olle Wreede
    Post

    The PrusaSlicer Thread

    Thanks, that’s much appreciated. I’ll have a look at your updated files and see if I can figure out how to fix my profile.
    Post by: Olle Wreede, Mar 24, 2020 in forum: Getting Started
  12. Olle Wreede
    Post

    The PrusaSlicer Thread

    Does anyone have an updated profile? I’m using the profile from @Killercds and it works pretty great. Unfortunately I have two issues in my...
    Post by: Olle Wreede, Mar 23, 2020 in forum: Getting Started
  13. Olle Wreede
    Profile Post

    Calibrating my tool changer

    Calibrating my tool changer
    Status Update by Olle Wreede, Mar 21, 2020