Separate names with a comma.
Sorry for disappearing, i was away on a trip (and leaving again on monday, and leaving again next sunday, ugh...) I had 0 luck with PA tuning. I...
Mine's still holding up okay. The electronics panel has a slight beginning of a crack on the very edge where it mates with one of the aluminium...
I've got that on my BigBox. I think it works better because the lip around the edge is a slight bit thinner than the glass, and also is a rougher...
Sidenote: i've since changed the config to assign all 4 fans to all 4 tools, so M106 controls all of them in unison. Had to do that because...
Woah! That will be awesome!
The test script could be rewritten to reassign the fans again, though.
That's basically what my mod does - except instead of bending the whole arm i just bent the tip (actually, the whole thing bends a little because...
I left on a trip for a week and a half, i wonder what i'll find when i get back. Before i left, the replacement panels that i've installed with 0...
Any particular channel that seems to work better than others?
Thing to note - I haven't noticed any change in print quality with or without the side panels in place. As long as everything is tightened, I...
Yeah, I wouldn't go for aluminium either, printer's heavy enough as it is. It's not so much about lifting as about whatever you put it on. I...
Ideally, it'd be awesome if more advanced scripting were possible and you could, for example, rehome C and retrigger the tool pickup macro if tool...
For what it's worth, silicone washers and no thread lock seems to work just fine for me so far.
Bear in mind that CF will completely block the WiFi if you intend to cover the rear as well.
That's what I was getting too - my wipes work for a while, then eventually, there's filament left on the wiper or the brush and it drags a whole...
