Separate names with a comma.
I have received a new fan, put the 3d printer together with a bit of thermal paste between the heat break and the heat sink. Then I tightened all...
I have had a look at the bigbox assembly of the v6 hotend and I have noticed at the first part it says to apply thermal paste. The original hotend...
Unfortunately I don't have any equipment to measure the temperature at this point in time. I will go to university and ask if I can borrow a...
The printer I have (prusa i3 mk2s) doesnt have the original blue shroud that comes with original e3d v6, instead the cold end is fitted into an...
Hello everyone. Im quite new to the 3d printing and I'm not too sure how to fix few problems. What im struggling with is mk2s keeps clogging with...