Separate names with a comma.
Thanks. You have done a great job !
Is there also a standard Simplify 3D profile linked with the mirrored hybrid Titan ? I must admit that at the start it was much clearer than it...
I followed your advice and switched the cables so the 1 is now the right extruder (direct titan ). Thanks for the help. I noticed that the docking...
If I understand correctly I should also use the Mirrored MBL Firmware. I connected - the left nozzle with the bowden extruder on the back and...
Looking where the nozzles are at that point in relation to the bed : - left nozzle is at X0-line and the right nozzle is at X68-line. That cannot...
I started with BB1.0 dual an decided to move toBB1.1 dual hybrid Titan MBL. I used the motors in the Package. These 2 extruder motors are 200 step...
Is it correct that in the dual hybrid set up only 1 print cooling fan is used connected to FAN0 ?
You are right. That was the problem. I switched them and problem solved ! Thanks.
The printer is assembled. I made my first print. The 3DBenchy seemed OK. After that I wanted to print a cube 20x20x20. The print was ok, but when...
I used your instructions, but at the last command pio run -t upload i got an error : System wide configuration file is "home/pi/.avrduderc" User...
Where exactly an how has the thermal paste to be applied to the heat-break ? on the screw part only or also higher on the plain end?
