Paul Meyer's Recent Activity

  1. Paul Meyer replied to the thread Magnetic heat bed - stick on glass or direct on heater?.

    Three years ago I bought one of these: link (it was a bit cheaper then!) came with aluminum sheet that fit as a glass replacement (lips...

    Jun 5, 2023 at 11:00 PM
  2. Paul Meyer replied to the thread Advice on reviving tool changer?.

    I’m a chip designer and programmer. I’m very comfortable with scripts/python/command-line-tools, etc. I’m used to quick development...

    Jun 5, 2023 at 7:36 PM
  3. Paul Meyer replied to the thread Advice on reviving tool changer?.

    Thanks, I’m catching up now. I have Klipper/Octopus/can-boards on my voron, and realize duet3/toolboards is comparable. I’ve got...

    Jun 4, 2023 at 4:07 PM
  4. Paul Meyer replied to the thread Eliminating Prime Wipe Version 2.

    any update on this? Did the teflon lined heat breaks help?

    Jun 4, 2023 at 2:43 PM
  5. Paul Meyer posted a new thread.

    Part cooling fan suggestions?

    I still have the original part cooling fans installed. After trying to dial in a melting benchy I realized the fan was not doing any...

    Forum: Tool heads & ToolChanger

    Jun 3, 2023 at 6:04 PM
  6. Paul Meyer replied to the thread Advice on reviving tool changer?.

    Thanks, I'll look at the setup. What drove the switch to 6HC? Are your toolboards mounted on the toolhead? how much do they weigh?...

    Jun 2, 2023 at 3:57 PM
  7. Paul Meyer liked dc42's post in the thread Advice on reviving tool changer?.

    You can find the configuration files that I used on my TC (before I upgraded it to a 6HC + tool boards) at...

    Jun 2, 2023 at 3:52 PM
  8. Paul Meyer posted a new thread.

    Toolchanger revival blog

    I've got my toolchanger alive again (gathering dust for ~3 years, life got complicated). It moves, picks up two tools, and has laid...

    Forum: Tool heads & ToolChanger

    Jun 2, 2023 at 3:51 PM