Recent Content by Paul Meyer
-
I still have the original part cooling fans installed. After trying to dial in a melting benchy I realized the fan was not doing any PWM. Either...
Thread by: Paul Meyer, Jun 3, 2023 at 6:04 PM, 0 replies, in forum: Tool heads & ToolChanger -
Thanks, I'll look at the setup. What drove the switch to 6HC? Are your toolboards mounted on the toolhead? how much do they weigh? Adding X/Y...
Post by: Paul Meyer, Jun 2, 2023 at 3:57 PM in forum: Motion System -
Thread
Toolchanger revival blog
I've got my toolchanger alive again (gathering dust for ~3 years, life got complicated). It moves, picks up two tools, and has laid down the...
Thread by: Paul Meyer, Jun 2, 2023 at 3:51 PM, 0 replies, in forum: Tool heads & ToolChanger -
Got an early e3d tool changer (end of 2019). Assembled it, got a print or two, struggled a bit with reliability, then life got busy. Getting...
Thread by: Paul Meyer, May 30, 2023 at 4:32 AM, 2 replies, in forum: Motion System