Separate names with a comma.
After seeing many different designs but not finding any models I designed my own BMG nearly direct drive. It uses the standard v6 toolhead, and am...
This is simple and effective - could you by any chance post your SLT of the bracket? (I see it includes a cable tie and attaches on two planes -...
Thanks for sharing - I definitely love the air flow use for cooling the motor :) Have you found a way yet to add a print fan? The whole unit is...
Hi Jai - any update or chance to share your design? Your design seems super interesting and utilizing the spare parts is genius. Thanks! Pierre
After trying a lot around (Bowden and Nimble-type remote direct extruder) without success I have finally built an Aero-based extruder. Works like...
Nicely done! I had myself designed a similar one, but had trouble with all the cables being very tight fit don there, and trying to stay a bit...
Hello, I have been playing around with 3mm filament, and I think I am seeing the same challenge as Andy with the Nimble extruder: the force the...
Closing - I think I have found the culprit: as usual kicking myself for overlooking the simplest cause... After going through all mechanical parts...
Greg, I used these without changes: https://github.com/e3donline/Slicer-Profiles/blob/master/Simplify3D/ToolChanger.factory
Colorfabb PLA, printed at 200deg.
This is what I am getting... Stock settings using Simplify3D. While the Benchy came out ok, so really puzzled. I'll check tightness and slow down...
Thanks Greg, I ensured the motor pulleys are properly tightened. I could tighten a bit more, but I don't think they were loose. In any case after...
Yes, the toolhead looks fine and I had the same idea that the bar is not going far enough. I have been going through the Step 10, and have just...
The actual error is that the bar is attempting to turn but not doing so (or minimally). This happens at all tool docks (T0 to T3), and when I do...
