Separate names with a comma.
Thanks for the Titan extruder. It was quite a lot of work to put it on my Mendel90. I wanted the lid facing the front which meant a lot of work...
I have a printer with an E3D and am building a larger one. I would like to fit a Volcano but don't need another E3D. Do I just need...
Thanks Sanjay. It seemed weird to me too.
I have 2 of the v5 and the heatbreak is the same size on both so that isn't it.
I continue to be mystified.
Any thoughts on the cause?
My extruder and carriage are printed in standard PLA. With the low temperature of the top of the E3D there is no problem. That high temperature...
http://i1361.photobucket.com/albums/r66 ... 5ff407.jpg I had some problems with a jam on the first one so switched to the second some while back...
You can also just loosen the nozzle while it is hot, let it cool, change the nozzle and heat it for final tightening.
I have a 40mm fan fitted as per viewtopic.php?f=13&t=194 . The bottom fin is not even warm in use. http://www.dx.com/p/hongfu-reprap-prusa ......
I switched nozzles quite a bit for a while but eventually the thread on the heat block stripped. It has to be treated with care.
Hi Sanjay, thanks for the clarification. I think my older one must have a bit of old plastic stuck in it from a jam as the heat sink sits higher.
I just got another hotend for my 2nd printer, a work in progress. I noticed that the spacing between the block and lowest fin is 2mm - quite a bit...
