Razar

MBL working great and BB printing better then ever :)

Hoping someone make the guide how to enable MBL some time.. ABL and I are not friends.

Volcano up and running, time to finally print BIG.

Replaced the 24V fan with a 12 V fan. This is a worthwhile upgrade since its so much more quiet.

Was trying to Print a fan guard...I then noticed some print residue from the nozzle and used pliers to remove it.. Jam pliers in fan.

Just placed a order for Antivibration dampers and DRV8825 Stepper Driver for XY Time to get the Y to shut up-

After a good amount of failed prints i conclude that slic3r is not for me and move to Cura...

Flash to R6 done that was rely easy using the XLoader... This should be the recommended way for sure.

Printed half of a Benchy today im impressed by the quality now after some minor tinkering. Had to cancel since i ran out of plastic.

First successful print yesterday. Time to go crab fishing with my newly printed boat.

Hetend Clog cleared by dismantling and gently heating it up with a lighter i then used a nail to push the filament clear.

Currently trying to unclog my Hotend after heat-creep issue. Other then that feeling proud to have built the BB Pro.