Separate names with a comma.
Currently in the process of being manufactured, should be launched around mid-November Thanks, Rory
Yes, I'm currently in the process of gearing up for volume manufacturing of these.
Just so we're all on the same page, are you thinking of something a bit like a motor clamp but miniaturised? If so I think the idea could have...
Loving the design with the screw in head, would allow for a range of new options and keep the groovemount purists happy too. I'll look into this...
I have 3 sets of M14 heatsinks and collars left to give out to testers, who would like one? No strings attached, all that I ask is that whoever...
I don't know what the paradigm we'd go down yet, suffice to say we would NOT ask everyone to redesign everything. Making it back compatible or...
Yes, quick connect heaters are in the works, we already have these on the fans and sensors, makes sense to do if for the heaters as well. Can't...
True, this is something I've been thinking about. My thoughts were that the nut is surprisingly big, 19mm AF and 6mm thick (even for a half nut)....
Having the plain section should also address both issues, there should be enough thread to go through a 3mm plate and use a nut on the other side...
In terms of dims for the M14 prototypes I've had made up, the collar is 26mm OD and the hole PCD is 20mm. I've started redesign for M12 and the...
Spoon, I don't have enough info yet on wear as the only way to ascertain this is from testing (hopefully by giving out samples for testing, you...
Hi Stian, I can see your pain, you could rotate the heater block by itself and screw it a little more or less along the heatbreak (you can get...
Hi Tim, I love the idea of integrating flange mounting and groovemount for an all in one solution. That said I would like to explore having thread...
Hi Ian, I didn't make it particularly clear in my post, the grub screw would clamp against the plain section at the top, even the thought of...
Michael, the plan was to use a regular black oxide / stainless grub screw, the idea being that you would screw up against the plain portion at the...
