Separate names with a comma.
Well digging in the manual and I found one of two references to the ball size, 2.5mm
2.5mm shown sitting in hole.
So I call my local ball...
Thank you everyone for all the ideas. Had it not been for your ideas I would not have thought to inspect it the way I did.
OK I have good news it...
OH I forgot about the balls in there. Oh well lets see where it all goes. I will report later tonight on the heatgun job and see if that works.
Off to buy a new hot air gun today. Mine is about 10 or more years old.
Going to try this and see if I can get it fixed. The problem I have is...
Will a heat gun get that hot? My Milwaukee wont.
OK guys I am an intermediate 3D guy. My son is a much higher intermediate guy than I.
We are both about to have lasers come out our eyes.