Separate names with a comma.
Ah yes. Now that I know the words to Google I am seeing that an Ultimaker 2 requires a PT100 sensor. Some detail always gets missed when putting...
It's plugged into "Temp 1". Did I make a mistake by assuming it would just work with the new sensor?
It's one of the Ultimaker copies from China. This one to be specific. I am not certain about the resistor at all.
Just pulled it out of the heater block. It's reading a resistance of 103.9. Then put it back in, 100.3.
Oh, one bit of info I forgot. The thermistor reads a resistance of 109.2.
I just installed the E3D V6 on a new Ultimaker 2 clone I am building. It's the 24V 1.75 universal model. I setup the included thermistor in the...