Separate names with a comma.
@R Design I could see that if anything had changed. That's what's so aggravating about this. The only change from Friday-Saturday-Sunday to...
@Old_Tafr I'd already thought of the fans so I dropped them as far as I could. I actually screwed up on the first attempt and got them too low...
Well, it's not a change in the part cooling fans. Thought one or the other may have worked loose or something. I carefully reseated them to just...
I got my BB Dual online last Friday and have been having a good time printing and experimenting with filament. I got a nice clean print of Benchy...
Well crap. I thought I hit "post" on this last night. Anyhoo, thank you for the suggestions but it "just started working". I have no freakin'...
OK, based on digging through forums for the last hour I believe I have a PID issue based on the wavy lines in the Benchy print and looking closely...
Annnddddddddd. . . . . it didn't work. . . Printing with a Fr of 50 had no effect on the width of the extrusion. [IMG]
@K2B: Fortunately I spotted that on the build. While doing the prebuild subassemblies I saw that the extruder body had a bit of a problem. The...
Still not sure what you mean by "swap the stepper drivers". Are you saying the built-in drivers on the Rumba board are movable or are do you mean...
@Rob The stepper rarely misses a step but will on occasion. Most of the time the gear chews through the side of the filament and I have little...
OK, for 2 weeks now I've done everything I can think of, gone through the calibration section numerous times, read every forum post I can find yet...