Separate names with a comma.
Very nice!
On a hunch... I tried M106 P2 not M108 as wiki calls M108 as "cancel heating" M106 P2 and M106 P8 both return the expected values and importantly,...
Thanks. I tried M108 P8 in the web console and get no response codes. I enabled P2 and tried M108 P2 and also get no response See image: [ATTACH]...
would I see a response in the console?
Thank you for the quick reply. Firmware Details: Board: Duet WiFi 1.02 or later + DueX5 Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 2.05.1...
I need some advice to debug a part cooling fan issue. Tools 0, 1 and 2 work fine but Tool3 has an issues. I can not get M1064 P8 S255 to enable...
Yes, for me too. Thanks!
Here is an update alternate V6 Bowden tool shroud. The fan mount tabs are beefed up and the hole is undersized allowing you to drill it to size....
Another Mosquito hot end tool mount. This uses the 713Maker mount. The corners need to be filed down on the mosquito no more than .02 in. This is...
I was going to experiment with an IR probe (https://duet3d.dozuki.com/Wiki/IR_Probe) and position each toolheads trigger surface at a different...
Assuming i have T0 active. if I park t0 T0free is called and the tool head moves away from the parked toolhead. Now assume I have T0 active and I...
