Recent Content by Scissors95

  1. Scissors95
    Post

    Is ASMBL still supported?

    I'm about to start. I have my tool attached and am trying to figure out how to make it talk to RRF3.
    Post by: Scissors95, Apr 17, 2022 in forum: ASMBL
  2. Scissors95
    Post

    Hemera wiring

    There are 2 cable bundles for the hemera tool. On the hemera itself you will use the cable with the heater/thermistor/fans and the ribbon cable...
    Post by: Scissors95, Apr 14, 2021 in forum: Tool heads & ToolChanger
  3. Scissors95
    Post

    High-Temp Capable Toolchanger?

    Yes, The bed can already do 250 and the exxtruders can do 300.
    Post by: Scissors95, Mar 26, 2021 in forum: Tool heads & ToolChanger
  4. Scissors95
    Thread

    Hemera tools are wide

    Has anyone else noticed that the hemera tools are so wide that they sometimes catch on each other when docking. I was able to fix this by adding a...
    Thread by: Scissors95, Mar 25, 2021, 1 replies, in forum: Tool heads & ToolChanger
  5. Scissors95
    Post

    C Axis Homing / Moving

    The center bearing and outer rod plates are the same height. It looks like my problem is with the weight of the hemera not allowing the rod fully...
    Post by: Scissors95, Mar 22, 2021 in forum: Tool heads & ToolChanger
  6. Scissors95
    Post

    C Axis Homing / Moving

    I am having a similar issue to sonderzug. The C axis seems to install when I go to pick up a tool however it seems to lock into place fine if I...
    Post by: Scissors95, Mar 21, 2021 in forum: Tool heads & ToolChanger