Separate names with a comma.
https://www.thingiverse.com/thing:4223811/comments used this one in the end I think. Really need to check it to be sure though. I don't have a BL...
I have setup the Hemera on my Ender 5 (not plus) and getting the marlin firmware up and going was "reasonably" easy. As I don't have a BL Touch...
[ATTACH] Found this but still not sure :(
Does anyone know the pin out colours and where to match them up for the Hemera extruder?
I love that tutorial! I show it to anyone I see melting solder onto wires :) I could just reuse the Ender heater and extend like you have. I also...
I have an Ender 5 with an MKS Gen L board and am going through the process of installing my new Hemera. The cables supplied don't seem long enough...