Separate names with a comma.
i see the 110v versions available . luckily i was able to grab both the 200x200 version and 300x300 version @220v when they were available .
Tool changer comes with only one bed size. What happened to all other sizes? I hope removal of those items is not due to quality control issues
there is no complete extruder package that you can put in a 200c chamber . extruder motor wont survive , carriage bearings will get damaged in no...
Titan aqua has plastic parts, thats why it cant be used. Are you planning higher then 80c chamber temp ? Good luck. Almost nothing can be used...
the nozzles are out . pre ordered 2 , 0.4 and 0.5
i'm sorry , its my mistake . i saw lots of chipping from the copper block , the chips looked like thin glass ,i thought it was part of the nickel...
unfortunately the nickel plating came off after around 30-50 hrs of print . print temp was never above 400c .
any plans to make tungsten carbide nozzles ? hardened steel nozzles loose hardness at high temps .
i managed to print it by printing thin layer of abs (like abs raft) and the ultem held with no issues .
i'm trying to print ultem (pei) with bed temp at 130c and it seems regular glue stick doesn't work (just makes crazy fumes). i'm having hard time...
i'm using both . my aluminium block was damaged at temps close to 300c , so i switched to copper block . also using TI heat break as i had high...
hey guys i wonder if there is particular reason for installing the heater block while both thermistor and heater cartridge screws are on the same...
