Separate names with a comma.
More lucky than I was then... my screw head is all rounded and I don't see how I could ever get it out. ( I mean except drilling it out) I just...
@elmoret, The problem is not that you can't clamp it properly, you can, but you can't unscrew it afterward. (I mean after a few heat cycles the...
1. I actually have a few of the blocks 4 or 5 sitting and I must say the block to block tollerances are very good. that's not the problem. E3d...
Well I got back to them a few times over the last month, they kind of admited they had a problem at some point in the past. But I wrote a number...
I just wanted to visualize the problem with the screw and drew the block dimensions and measured heater dimensions to scale to compare it with the...
Just to my experience, E3D support was really kind and helpfull and changed my heaters for new ones. But the new ones are again in the 5.81 - 5.83...
Ok I found my sweet spot on buildtak and it is around 245-250°C for edge with a 100°C bed temp (but I have 5mm glass and buildtak) so I loose some...
ok good luck
I checked the bondtec extruder it has drive gear to reduce the ratio / torque on the motor but there is still only 1 hub so the pressure on the...
Maybe avoid chewing the filament before feeding it to the extruder... No seriously.. I am thinking that it might be that the teeth of your...
Thank you for your support and help, I forsee a lot a trials ahead of me ;) It gives me a direction or many at least, which is invaluable to...
Hello, Unfortunately I can't because my differential optical sensor won't work on glass (actually my particular 5 mm glass) but this is another...
I am commissioning my new printer and having some problems printing with edge on buildtak. First issue is the first layet adhesion. Although I...
