Separate names with a comma.
Would you expect to see the mesh in the output of M501?
Aside from that obvious fail, how do you find the stock simplify3d profile in 3.1?
Well that may explain some of my fail! Thanks, I'll give it a go.
So, just to be clear, you've got s3d set up to add a g28 at the start of each job, and that doesn't clear the mesh levelling? Would you mind...
Do you have any homing process at the start of the guide?
So what is your normal routine for a print from cold start? And do you have any pre/post job modifications you make in gcode?
Ah yes I've seen that. As soon as I issue T1 it starts to slowly move the head over. So would you expect the RC6 firmware from your Jenkins to...
Is the problem to do with losing settings? It seems to lose the mesh bed calibration even though it's in the eprom. If I do an m501 I can see the...
Thanks, just got the .hex from here https://jenkins.alitecs.de/job/Geek/job/BigBox_Dual-RC/ Giving it a go now.
The file was called marlin_direct_dual.hex Where do I download the right .hex from @Alex9779? I've tried downloading his RC6 (here:...
I have an original Kickstarter reward dual. I'm trying to complete the commissioning section of the build instructions, and I've got to the mesh...