Separate names with a comma.
Ah, ok. So if I determined the E-Steps for a given filament with the calibration method described in the build manual, I'll just change the value...
Hmm, looking at the branches... if I have a Pro non-Titan, will I be able to use any of the two Pro branches? Also, does anyone know when/if a...
I just got around to testing the soap water method. Works great, and just as advertised. However, it really seems that it's a bit of a gamble if...
I'll have to see where to get wolfbite nano in germany. Or at least somewhere in the EU zone, then.
I haven't had the ABS juice on my radar yet. I'll give that a go after the Kapton. I've just spent 20 minutes trying to apply it without creases...
So, when trying to print ABS, my print usually remains in place until about 80% of the print is done and then pops off of the hotbed. I've tried...
For this project in particular? Because I have another thing that I need to print for my kitchen that will be right next to the stovetop, so I'll...
Very nice. Thanks for mentioning the cold vapor smoothing. Hadn't heard of it before. I'll give it a try and see what happens.
I'm printing a frame for a wall-socket to hide some wall-dent-ugliness behind it. I printed a prototype in PLA to get the measurements right, and...
Rod sag may be the thing here. The PCB looked fine when looking at the bed from underneath. For now, I just stuck 3 more washers under the PCB...
So this morning I've tried printing my first thing with large-ish dimensions (15cm on the X axis, 11cm on the Y axis). I've noticed that while the...
Ah, that may be it. I have to clean my bed frequently because it gets dusty rather quickly. I'll try to remember levelling it afterwards and see...
