Separate names with a comma.
100mm/s!! That’s fast!
With great difficulty and measurement.
Yes I designed it myself. It takes some ideas from other printers and parts on thingiverse but they have all been remodelled and modified in some...
Its not much bigger. I will just measure it. One moment..... 540 (width) x 520 (length) x 620 (height) all mm. 550-560 square wouldn't hurt...
Sources it all myself. I used 2 Y motors to gain some space plus I’m fairly sure some of the inaccuracies come from that long bar at the back. I...
With the duet firmware it’s amazingly simple! Set bed zero at bed center. Create a ditto tool in your config.g. Have a simplify profile with M579...
3030 frame. I wouldn’t say there are no vibrations as you will always have some. However, there is no visible issues caused by any vibrations. I...
@dc42 it works!! Just a quick note though! When setting the tool offset the X should be + and the U should be -. At least that’s what solved my...
That sounds like a great idea! Luckily I have had experience with delta printer when I fixed a friends! Although in the slicer I never moved the...
@dc42 I have put this in the duet forum too. I have done as you advised but I am getting “trying to extrude with no tool selected” errors? I...
Has anyone got simultaneous mirror printing working? I.e. left and right handed versions printed at the same time? @Alex9779 I think you ventured...
Yup to be fair it has almost completely lost its soul! Still it has the same motors as the original and... well... um.... not much else?!
You lose some Y by having the motors inside the frame so I would suggest perhaps moving them outside or finding a slimline motor with similar...
Thanks @Mark Curry I will have a look through it! Meanwhile here is an updated look at the BigBox with X/Y linear rails and 300x300 bed. I have...
Could I trouble you for your duet files? Config and the rest if possible?