Separate names with a comma.
From what i can see in the attached file ubl_probe_pt 2 and 3 has value 0?
This need to be within the range of your probe on the bed.
You need to change the pins for the PT100 in Pins_RUMBA.h to 10 and 9.
Check the Pins_RUMBA.h file in the stock firmware for more details.
You can find the plans for acrylic and partlist on Thingiverse.
I am not sure if it will work, but you can try issuing M420 S1 to enable bed leveling after homing (G28).
If you use M420 S1 V you will get a...
Looking at the video you posted it looks like you have swapped the connections for X and Y axis motor and X and Y axis endstop switch?...
The command should be the same, but you have to remove the ']' after the filename in your command.
Marlin use quad-step, so the limit is 40 000 step/s.
With 1/16 microstep on y-axis the limit will be 111 mm/s.
You can copy the custom gcode from the file into your config if the import does not work.
Here is the toolchange gcode for Oozeless tool change...
Are you getting the option to select BigBox_dual_both under the Printer Settings tab after importing the config bundle?
I think you need to run...
If you ordered a PT100 you probably got the wrong cartridge. Sounds like you have the 100k NTC thermistor.
I set up slic3r a some time ago with the same tool change script as S3D.
You can find the profiles here....
The easiest way is following this setup guide:
You cannot view the camera with a usb connection to your computer. You will need a network connection to the Rpi for that.
The hex file is too small to have the LCD enabled.
What profile/branch did you use when flashing?
I am not familiar with the Dual Titan, but I does not look like the values I pasted from the Pipshag repo is for a Dual Titan.
You need to set up...