Separate names with a comma.
Change the settings as described
That's a very nice print ;)
Then play around with the pot meter on the stepper driver until the missing steps disappears.
Hello and welcome! :)
For us to answer your question we will need a bit more information and maybe a picture or two.
I'm assuming that you...
How do those tables stand up to the vibrations while printing?
Fire extinguisher...smart idea btw ;)
You could always try the TL-smoother.
First try what I suggested in the above mentioned thread. Turn everything on and measure the voltage output of the PSU and adjust if...
Yes, had absolutely nothing better to do then to help out a dumb-ass... As you might have noticed the shaft length is the same for both......
Link or just use a ruler ;)
Dear BigBox, E3D & Littlebox,
I've been a 'fanboy' from early on. I was just 4 days to late to jump into the Kickstarter project, but followed...
my thoughts exactly... When going from a filament which needs to be printed with a higher temperature then the next try to extrude the second...
Can't you download it from the E3D site? Never had any problems with customs since I'm in Europe (Belgium) and all my orders where when GB was...
Does this also work with ABS?
After uploading a new firmware go in the LCD menu.
Select 'Control' --> 'Restore Failsave'
Then reboot the printer ;)
I second that. :rolleyes: