Separate names with a comma.
Wondering if welding some of the frame parts would work out nicer than fastening with screws. I vote to anodize it "rainbow" for the faux titanium...
Yes you are right about the look good and have some tests to go along with it. Though I find it way most efficient to make ugly, useless print...
Haha not mad at that. Just pointing out a common observance. To be honest, I never really understood the whole thing about benchmark test prints....
Bummer. I bet it didn't taste very good.
Sounds like still at least another month before shipping resumes?
Lucky. Do you have image capture from both camera modules to compare the field of view when mounted on the bigbox?
It wasnt available before. I'm guessing the supplier doesn't have enough acrylic and e3d decided to take all that's available now so they can push...
I'm not ready to pull out just yet, but at this rate I think I may be looking to buy a Taz 6 in the meantime.
There is a widespread issue with bad lenses. Might want to hold off until it is all settled....
@JohnEsc I am actually disappointed you haven't printed optimus prime yet. LOL http://www.thingiverse.com/thing:1391911
Nice John. A BigBox printing a Bigbox. We must go deeper! Is this going to be a thing like Lulzbot where they print a Rocktopus with every printer...
You are a brave man with a steady hand.
A little bit cliche and boring that everyone and their mom's 3d printer mascot is a robot. ie Ultimaker and MakerBot. Who here entered in the contest?
Mike, are you a preorder or kickstarter backer? Looks like you have a cut v1.1 top piece. I thought only preorders had those mods, but I also spy...
Would it be possible for you to upload a short recording on your phone. Curious to see what's going on in the hobbgoblin part. Not sure if the...