Separate names with a comma.
Did find this in configuration_adv.h // Default settings in "Auto-park Mode" #define TOOLCHANGE_PARK_ZLIFT 0.2 // the distance to raise Z axis...
Yes, I do have access to the firmware code. It's required a significant amount of modification to get from a very finely tuned single extruder...
Have a Kossel Mini with RAMPS 1.4 and Marlin; printing via Repetier host. I have successfully printed 2-color prints, but at the time the color...
According to the schematic, they are 15mm center to center. Initially, I set my offsets to -7.5 and 7.5. That seemed logical, but then my prints...
And, how is the stringing now that you adjusted the PTFE tubing? (BTW, I agree, tapering the end of the PTFE that sits into the hotend is a...
Can't seem to located it in any of the documentation. I can measure, but assume it's a standard value... Setup is a Kossel Mini with RAMPS 1.4...
100% cooling. All the time. I fought filament feeding issues (commonly listed in the forums as "hot end jamming") with the E3D v6 for a few...