Separate names with a comma.
OK I found them.
Did you do something special with extruder wiring? I have the pancake motors. And When I try to extrude they just vibrate....
thanks a lot!
Do you use BL touch?
Finaly I had some time to install Duet3D with t100 board, Duex5, 7" screen and BL touch. Now it's just the matter of cofiguring it all.
Same thing here. I'll like to have options to add stuff later. I hopefully getting my tomorrow.
Is rumba 5V?
I have same problem with RC8. Something is wrong. Hot end fans are running all the time, BUT They turn of if I remove Zmin! Must be something...
How did you guys connect you BL touch?
Black and white -> min Z endstop.
Brown and red -> 5v
Yellow -> pin 5
Is this right?
It works when I test...
Can somebody help:
It won't home Z.
I went allin and got me Duet (Ethernet), Duex5, 7" screen and pt100 board.
It hurt My wallet a bit.
ok thanks. I ordered Duet board today so I'll stopp my build until it gets home. Thanks for all the help.
Folkert: What extruder do you move with "move axis X"? I'm gessing the one on the right. It moves as expected until I try to auto home. Then It...
Will test rc8 tomorrow.
I had a few problems with rc7. One of my pt100 sensors died. So I got maxtemp error. I'm now waiting for à new sensor...
Thanks a lot.
Will try it soon.
Do you also use Duet?
Is there anyone with this mod using original board with Marlin? Any firmwares out there?
How did you guys...
Only cable management left. Folkert Molex QD solution for exchangable heads. BL Touch.
[ATTACH] [ATTACH] [ATTACH]