Separate names with a comma.
We don't have the capacity to produce the number of panels required in house, they are produced for us offsite. We have recently swapped to...
Read this and pay attention to the bit about the scripts | https://duet3d.dozuki.com/Wiki/Gcode#Section_T_Select_Tool
I didn't make it. It was written by someone else. You can put a comment on the guide and see if they respond.
The offsets are set in the config.g...
It's in config.g look at the bottom for the G10 commands.
This may help | https://e3d-online.dozuki.com/Guide/Fine+Tune+Z+offsets/119?lang=en
yup, those are.
Yup, also the z-axis endstop is on the toolchanger head. no need for sensors on the tools, they'll only get ion the way anyway.
300x200 is the biggest i would go with a cantilevered bed. After that I would go with three leadscrews much like the railcore. doing that does add...
Could be bent? The Z-Axis is built like a brick sh!t house. If you manage to bend it you have done something horribly wrong.
Hiwin or IKO
Here's a good starting point | https://miscsolutions.wordpress.com/2020/03/02/converting-the-e3d-tool-changer-to-duet-3-with-hemera-tools-part-1/
It's standard MGN12/9 rail and H variant block.
for everything else....
You can do anything you like :)
Something that sucks and can be fed power from a PSU.
They plug into the PWM output on the duex5
look through the config file for the PWM pin
What would you like to know?
Attached is my config file. Match the wires to the pins.
If you haven't already seen this video from Thomas Sanladerer, it is definately worth a watch | [MEDIA]
David Crocker has done | @dc42...
Short answer is this is something we haven't done yet. Overhangs are an unsolved problem. Current thinking is to use a t-shaped endmill, or...
Can you post photos of your setup? Also where did you get the parts from? What voltage is your system?