Separate names with a comma.
The version of my BigBoxis is B.B1.1
with the code generator ‘slic3r’ I decrease the retraction to 1.5mm
and also I increase the speed for...
There is something wrong with the extrusion.
The printer starting to print well, but at some point
it doesn’t extrude plastic anymore (see...
Yes! the bully was loose.
On the bully there are 2 holes. One is empty and one there is a screw loose.
So I set the screw fix on the flat part of...
I have a problem with the X-Axis Motor.
When I do Auto Home the Print Head is moving not in the correct way
along the x-axis. It stops...
I have a problem with the X-Axis movement of my printer.
See the video here:
I didn’t use the printer in the last month and when...
ok, I connected to raspberry pi with octoprint, I clicked settings and
follow the configuration as the online manual of octoprint
Then I try...
I selected Auto home before to activate the 3DBenchy.gcode
but again nothing happens
I tried to unplug the usb from the rumba board
and again I selected the 3DBenchy.gcode from the SD Card
but nothing happens as before
Here is the...
After Calibrating The Filament,
I selected the 3DBenchy.gcode from the SD Card and Push the knob
with the temperatures at their required values....
thanks! the ‘Auto home’ and ‘Level bed’ step now work :-)
I moved the IR-sensor a little bit down and the IR-sensor flashes when the bad is...
I checked and the wires for the IR sensor are well connected at both ends.
When I perform the ‘Auto home’ I see a red light from the sensor....
I think the IR sensor is not working :-(
I tried to move my hand underneath it and no red LED light.
then I moved down the z axis to 100mm and I...
I have just unpacked the Factory Assembled BigBox and I had a problem
After Loading Filament, I tried to Print the preloaded #3DBenchy# from...