Separate names with a comma.
I ended up sealing the block onto my extra Hemera with RTV silicone and tested it for a few hours last night using an old Danger Den 12V PC...
I have also been working on a water cooled conversion over the past week or so. The approach I am using is to print a block out of resin that...
I am sure for some situations the Noctua would be inadequate. I rarely print PLA or any layer under 0.25mm, and I only print larger structural...
I have been using a Noctua 40x10mm fan for my Hemera on an open air railcore printer and it is more than adequate. The heatsink is barely warm to...
I think you are right on the mark about it being from moving the fame. My panels were all fine until I started lifting and rotating the frame to...
Similar to what others have said my gear set was extremely tightly meshed. It was very hard to remove the drive gear when I disassembled the...
I started having similar issues after about 50 hours of printing. The extruder would randomly miss a step here and there for no reason, which...
Add me to the cracked panels club. I assembled the panels finger tight using a screwdriver type hex driver and did not use threadlock on any of...
