Separate names with a comma.
Sorry for the late reply, I missed your post. Yes, I use the TC with all the tools on standby all the time. I toggle standby-temp between 0°C (for...
Well, all true, but don't let ampere out of the equation.
Not 200°C, but you can do 120°C.
I issued a pullrequest on config.g :)
fishing for compliments :cool:
There is a process called "hot tightening", that you probably didn't do based on your description.
Maybe you want to take a read:...
I see what you are doing and I like the RRF3 provides us with such possibilities, but what do you do, when P0 happens to get worked on?
Actually, everything is referenced to an imaginary point that also happens to be in the same spot as the actuated Z-endstop knub because a clever...
@Greg Holloway Any specific reason for the extruders to be at 8 not 16µS interpolated?
I have mine at i16µS aswell.
I did put a simple magnetic sheet onto the e3d-heated bed and done. Think of something like wambam or such. You can get stuff like this for <20€.
I didn't check your code, but want to tell that it is bad practice to do this via slicer setting. Instead, you should execute this via firmware,...
I don't know much about the imperial stuff that only the minority of 3 countries use, but for the remaining number of 190 countries worldwide its...
You are right, I did create a pull-request for removing the last line from homex.g and homey.g aswell.
Minute 19:14 and later:
1.83m closed loop GT3 belt is long enough for one belt. Thats the longest you will get a GT3 atm.
Do it! :)
Don't do it! ;)
Be sure to set active and standby temperatures of each used tool via G10 command first.
generic example start-code for on a toolchanger:
Thank you very much, I just have a look at it. So far, it seems to be a good base to start with. :)
A minor flaw you maybe want to fix in your...
Any special reasons why you decided to do that?