Separate names with a comma.
I'm interested. My Prometheus just arrived, and I'm debating over installing it on the BigBox or my older delta.
http://www.fabbaloo.com/blog/2017/2/17/3d-printing-management-lessons-bigbox-ceases-production
That's a good question. This wasn't a highly detailed model, and it was pretty coarsely printed (I think 0.3 mm layer height) because the whole...
I had decent results with casting aluminum in a "lost PLA" mold. I printed the model in PLA, then invested it in a mixture of plaster of Paris and...
Hmm... interesting idea!
As of now, the USB to the Pi is disconnected, and I am using the Pi only as a webcam to monitor the printer. I suspect that the IR sensor is...
Hi, all. I took a long (several month) mental health break from my printer, but came back to it this week. I had been having terrible trouble with...
Thanks!
I backed the Prometheus kickstarter, planning to try it on my BigBox. I've looked through information about the BigBox and the E3D hotend here,...
The first thing I would do, if you haven't already, is double check all of your end-stop wiring connections on the control board.
Me, too. Just make small adjustments to the sensor. I backed off the mounting screws just enough to let them provide a little resistance to my...
I never had good luck with the procedure as described in the online instructions. In fact, I ran into exactly the problem you're describing. My...
Thanks, everyone, for the good suggestions.
I don't think there's much stress on those parts at all. Resin should be fine. I used resin for a couple of lever-end knobs for my car, and have...
I have 8 Misumi bearings ready to go. I saw a thread that said the Z axis bearings can be replaced without disassembly, but I can't find it now....
Looking forward to seeing what you think!
You've probably already checked this, but when I first finished my assembly, I had the wiring for one of the motion axes and one of the extruders...
^^ That. I would try unplugging your Octopi. There is a thread somewhere about the Raspberry Pi having the wrong image on its microSD card and the...
Do you have the nozzle and bed heated before running the gcode?
I know you've said you checked the wires for the Z end stop and found them well connected. I had a similar problem with an axis end stop when I...
