Separate names with a comma.
I think I may have found the issue - I was using Alex's BigBox Pro Simplify3D profile which uses Relative extrusion distances (G-Code settings)....
Just noticed that my OctoPrint (latest version) is no longer showing the gcode properly. It shows the moves and retracts fine but the actual...
It was the stepper driver. Now one arrived this morning - swapped it over and all working again! Thanks for the pointers!
Ahhh - didn't think that it may be the driver board - will try swapping those over and seeing if it is that! - Thanks!
Sorry, I should has said I swapped out the original motor for a different working one and that has the same behaviour (ruling out a motor issue)
Halfway through a print the other day and all of a sudden the X-Axis stepper suddenly started behaving really oddly in that it suddenly just...
Dremel for us to - very slow and very little pressure which worked
1000 times this. This has been (so far anyway) the worst part - when it comes to tighten up the screws on these parts and you find that the...
