Separate names with a comma.
Just bought one to AliExpress. Received a part set that looks SLS printed, fairly good quality. I only doubt durability, because a steel gear on...
See "project Whisper"
Another option: Use a Clever 3D PEI coated aluminium bed. Some advantages over glass coated PEI: *Aluminium thermal conduction is many times...
Check for bad contact between the head sensor and th PT100 amp. I have sometimes same phenomenon which end up with a MAXTEMP error. I cure this by...
Y endstop is sometime erratic, once a couple of day typical. Autohome starts, and suddenly, without any visible reason, X axis is going to the...
Fans maybe. they are not tight fitted on the head, so they make noise. My fix: my business card cut in small triangle piece and inserted between...
Using aluminium bed recently, I found 2mm difference in setup. When using glass, I use a special spray , Dimafix, for holding ABS and it fits...
You can also drill a 6mm hole in the middle of SD slot in the acrylic to make sure to extract micro SD with a plier. The only thing not to forget...
I am thinking about putting some tissue, like the one you use to prevent mosquito in your bedroom (I live south of France) between acrylic plate...
Hi Alex, I have the same problem time to time only on my dual's right extruder temp is 10 to 15° higher than ambiant, then fans never stop once...
Also check there is no plastic/filament/extrusion debris in the fan. Mine did already block twice, each time a small piece of plastic entered...
On S3D, I use 85% coefficient, and it works very well.
8 hours so far, i could not do more because I have to shut it off when I leave home, and also because I print relatively small technical parts.
For adhesion, I am experimenting now DIMAFIX http://www.dimafix.com. Works nice with ABS,PLA,NYLON, Colorfabb NGEN so far. For instance with a...
Had the same. Ended up with PID parameters more agressive (P=40 I=25 ...) and it works like a charm since. THERMAL RUNAWAY is another story: I...
I coat my bed with a drop of ELMER'S glue mixed with water and gently wiped with a tissue. I have found then 1st layer problem: nozzle is...
Same for me. I had some experience already with a crowfunded printer that I spent almost a year to modify and twist to make it working, then I...
Go to FARNELL for instance, and forget about de crimp tool. A sharp plier plus some training will do the job easy, and you can buy thousands of...
