Separate names with a comma.
Clever3D PEI plate, E3D glass plate blank and an E3D glass plate covered with PrintBite+ foil. Haven't missed a flexible plate yet.
Couldn't we move the motor cable to the other side and mirror the cover? Then these two couldn't interfere to begin with.
This should work brilliantly. I run 0.3mm distance at 30mm/s and 0.1mm coasting in S3D. Approaching insane quality, the Hemera after just a few...
You're most welcome, that's what a community is for! :)
Do you mean the small heater block below the heatsink?
I believe they are relative to the probe switch that does the z-homing and bed probing. My approach always was to get the tool pickup to work,...
In your config.g, look for these lines fairly at the bottom of your fille: ;tool offsets G10 P0 X-9 Y39 Z-4.65 ; T0 G10 P1...
https://github.com/e3donline/Motion-System The panels are in the DXF folder, for laser and waterjetting, these should do. If you need to machine...
Glad to hear that, happy printing!
https://e3d-online.dozuki.com/Guide/V6+RepRap+Firmware+Configuration/26?lang=en...
White lithium works well for me so far.
I dont' believe it is a good idea to change tools that way, especially not with a spindle like that - you can easily cut aluminium with it,...
Enjoying Hemera on the TC, it is simply wonderful
Instead of putting something in the toolhead, wouldn't it be easier to check for tool presence by having a switch in each dock and check there? If...
I haven't printed anything big/long yet, but I did PLA, PLA/PHA, XT-CF20 and PETG/EDGE with it so far, no problems whatsoever. PLA I run at 205°C...
I run my Hemera at 1200mA on a Duet2 with 24V and haven't had a problem whatsoever. At first I even forgot to tune down the amps and it was...
I asked about stiffening the frame with profiles during E3D's Toolchanger livestream (Greg and Sanjay) and they almost told me off for even daring...
That is not a bad idea. Why did you not leave the bottom closed though?
Well, if that is the case, I'll go ahead with the full conversion then, thanks for the info!
Got 1 Hemera running in bay 3 of the TC and it is working flawlessly. Even the first benchy in XT-CF20 turned out incredible despite not even...
