Separate names with a comma.
No not really. Around 190c, but have tried both lower and higher. I printed a big lampfoot, that did change colour in the beginning. It sits in...
How come so many say e3d have 0 ooze (v5)?? Mine snivles like a dog with a cold.. I think i have got a real "monday example".. = troubles,...
I drilled the heatbreak ( is still have an original to revert to) to 3.2mm instead of the original 3.1, now it seems no more jams. I think my...
The UV changing filament only works for a week or two. After that it won't react to the sun anymore. Only printed objects that is. On the spool...
I am getting tired of this now, i have jamming problems again. Especially with ABS. Nylon is still printing ok, but that is because nylon is...
I got the new v6 nozzles and they print really good now (without drilling ;). I have printed a lot of different nylons, PLA and Ninjaflex, not had...
Josh: I have done a lot of testing lately. I had success printing ABS after the drillout of my 0.6 nozzle, but still a lot of sticking with NYLON...
I have been really successful in printing a lot now with drilled 0.6 nozzle. My new favourite material to print is nylon. I have been using...
Grr.... the 0.25 nozzle blew open after 20minutes, it seems i drilled too much so the walls got weakened :( Getting a bit tired of this bull......
Makerbot PLA did i print at 190c with original hotend, on e3d i have tried up to 220. The 220 i wrote above is for the PS1 ABS, but have tried up...
I should add that extruder is calibrated and also PID. Temp in range of one degree.
Sure. I also handdrilled with fingers, but as Mike i was also too eager...this was before i got the heat/insert PLA/cool and pull method working...
I am actually having some success finally. I drilled the .6 nozzle to 0.8mm boredepth but still had some problems, so i tried another tip from...
I think it was a bad buy this hotend, because i want to be able to use everything to print. I am building a filament extruder to be able to do my...
I still have a lot of jams. I have polished the barrel + heatbreak, drilled out the nozzle, sharpened the teeth on the hobbed bolt, increased and...
I measured my 0.4 (3mm) nozzle and it was about 2mm. Now i have drilled it to ca 1mm and it seems to have helped (knock on wood).. We'll see...
I also have this problem with jams after a while, so i am following this thread.
It will not happen in a while because i also have problems with jams. So i am following the thread about this problems to see what happens.
All outputs on the k8200 board can handle MUCH more than is needed. The mosfets can handle 57A and 75 volts. If needed one can solder extra thick...
I will try this but i will remix it for even better stability and accessability.
