Separate names with a comma.
Put me down for being surprised. I worry about e3d putting on extra staff for the volume on the back of pre-pays. I for one pre-paid and will be...
I really hope someone has figured out the z offset?
They can be shimmed with a cut down piece of teflon tube. That’s how I did mine. I shimmed both top and bottom of the idler pulley.
Does anyone have a photo of how the Idler pulley sits? My idlers will be floating in thin air without a spacer underneath and above. Am I missing...
Yep, I'm in that boat too. Some succinct instructions would go a heck of a long way.
Seems like the jury's out on this. I ordered a set because my existing lead screws are bent. I figured the hassle of pulling them out and...
Any improvement in print quality?
Back to Bjorns build I go.
Is there a bill of materials? I have nearly printed all of the parts. I purchased the steppers and other items for Bjorns version, but I'm not...
I have started printing the parts in Edge. It will take me a while before I get them all finished. Then I will make a call on assembly. It does...
The big question is if this is a better design than Bjorns. It overcomes issues but does it introduce any new issues? I was a bit worried to hear...
Fair point. I assume you are running a fancy PEI build plate and not glass. I would try the IR probe from the Duet people if I had the PEI plate....
I also have a bltouch and have had nothing but a positive experience. It seems reliable and fast. The print adhesion and bottom layers have been...
Alex, the first (blue) part shown on the thingiverse previews looks tough to print. It appears to have a serious overhang. Any advice in how best...
Ha! I guess my plan has a fatal flaw.. incidentally my duex2 is quite small. Quite a lot smaller than I expected - which was a nice surprise.
I went for the Duex2 to hopefully avoid some of the misery that comes with fitting new equipment into that confined space. That being said I have...
Same here. Fat fingers on my part. I have the 7" on the way.
I have performed some crude repeatability tests. I have run the mesh level test 3 times without making any changes to the bed to check on the...
I have been working on my mesh leveling script. All my scripts are adaptations from others. My current mesh level which works great with the...
I have been tuning the distance between the hot end and the bed. The BLTouch was initially set in my config.g for that distance to be 1.5mm when...