Separate names with a comma.
Although the 1x2 microfit connectors (with the latch on the small edge) are quite common, the single row 2x1 versions (with the latch on the long...
Oh wow. I absolutely loath the clips used to attach the glass bed (I hear the ping ping ping of them popping off one by one from the other room...
Looks up PEEK pricing... oh my. What do you use to extrude it? can a hemera + volcano + nozzle x + PT100 get that hot, that's my goto toolhead...
I had something similar and found out that only while hot my hot ends had a little play in them and the tip would be to get pushed around by half...
I have heard that PLA is unsuitable for machining due to heat causing it to gum up the bit, I have had mixed results with printing ABS on my...
My ASMBL is coming along nicely, the only thing missing is the pully for the 3mm shaft (on it right now is a 5mm pully with a shim, it wobbles too...
Sounds like someone scammed amazon by swapping out the heater block and returning the hotend which was then restocked. Hopefully they don't just...
Thanks! Although I probably won't use a wipe block in general for now since SuperSlicer ones are a little wonky I was able to do a few test prints...
All my print heads have fairly different heights (hemera plus Bowden with some volcanos thrown in) so the basic wipers on the side don't work that...
So I have collected everything to build the miller except for the pully to attach to the brushless motor. I can't seem to find one, idler and 5mm...
I somewhat remember that a design goal of the toolchanger was to be able to add linear encoders easily and space was made to mount them. Which...
The shift wasn't small, when switching from the volcano/hemera to the V6 bowden, it would still have the z offset from the hemera/volcano and just...
With post processing but fairly minimal. The things my postprocessing script does is Move the initial toolchange from before the start code to...
I use plain slic3r, I can use it consistently across all my printers. I moved to it from repetier a long while ago. My main issues with it have...
How do you handle homing with a tool attached? the tool hits the edge before the carriage does when doing X and Y homing for me so it ends up with...
I just used flush head m3 screws meant for a countersunk hole. The bed holes are oversized enough that the screw heads rest a little lower than...
I use this one, the 215x315 version. It fits and works flawlessly. The only change I needed to do was replace the screws holding down the build...
I'm using 5/16" wooden dowels and they work great. I epoxied them into the base to give more stability.
I am actually working on using that same connector, except the plug is at the base and the steel guide is attached to the plug itself permanently...
It doesn't appear to be the duct. The fan barely turns even when not installed in the duct, at S255 it doesn't even reliably start spinning on its...
