Separate names with a comma.
very nice! how much does it weigh?
My standard bowden tools don't (when homing Y before X). If your tools do, you might want to have a little protrusion in the left front corner of...
...and what about KISSlicer? It seems to have some nice features, too. (@orcinus, are you using it?)
this recent article at least suggests, that S3D is still alive, but it doesn't give the slightest hint about a possible release date for S3D V5...
You just beat me to it buy a couple of hours :D I was going to ask the same question. I currently use Cura 4.6 for the TC primarily, mostly...
Implementing a tool-on-carriage check point would be easy. All you need for this is available and working today. Assuming you have the...
....for completeness sake, here is how I define the microswitches in config.g: ; Tool microswitches M950 J0 C"!^duex.e2stop" M950 J1...
I will switch to the paradigm outlined by @mhe but for the time being, I have the microswitches on the tools as described here. The system is now...
Everything works fine now ... almost :) It appears that upon executingG28 [axis], the homing state of the respective axis is cleared even before...
Thanks, that was the missing link.
No the conditional G-code is here in RRF3.01(rc11) I want to check if a tool is on the carriage before homing Z. But I can't figure out what the...
That's certainly a possibility. But you can't use it for bed leveling (G29) in that case. Yes, that would be nice :)
Currently, there are three points that keep me from ordering a Nimble: I wonder why Zesty doesn't use a dual hobbed gear - the basic design with...
Please, please go ahead and order it. We're all relying on you to make the comparison. :)
Is anybody using differential height sensor (sold by Duet and E3D) with the ToolChanger? How does it compare to the standard switch in terms of...
Would anybody happen to have ToolChanger profile for Cura handy and be willing to share it? (I have a job where the ironing feature of Cura would...
Might also be a hardcoded part in one of your slicer scripts
Loving the alien (and the ToolChanger, of course)
so the download link is functional again, that's good news...
Thanks for the kind words @Jai Stanley Allegedly, the Duet V3 firmware is backwards compatible, i.e. it can be used for the Duet2 series also....
