Separate names with a comma.
Hi. Regarding this Project whisper. Has anything been done with regards to setting the steps for the drivers on the Ramps-card? for example,...
Vet inte riktigt vad du menar med kampanjen min min står här färdigbyggd och väntar på att jag ska ha ork att trimma in den ordentligt. Och jag...
Ok, so for the next step. Is there a way/method to run the PID-tuning and recieve the feedback without the OctoPI/RPi?
Henrik, Dual kickstarter och boende i Götet.
Hi. Gotherburg/Sweden here with a dual. Do not know if there are any other Scandinavians here lurking around? Anyway, I work as a Design Engineer...
Tough one. I would say that the only way to get a ok result from a print like this is this split it up into pieces. It will require a bit of...
@mike01hu Hi. Yes, this is the procedure I'm used to and the way I usually send commands to my printer, Only this time the commands only cue up...
While I'm on this subject. Regarding the PID-tuning. I do not have the OctoPi so.. Is there another way of sending commands to the Marlin, ie via...
Thank you very much for the answers, I believe I have enough understanding of this phenomenon now to remedy it. Greatly appreciated.
Hi. I finished my Bigbox Dual-printer yesterday and am now trying to finish the Benchy-print. ¨ I get to about layer 10, then there is a thermal...
