Search Results

Search Again
  1. Michael Horn
    Post

    What firmware would you like to see?

    RC6 Hybrid Dual Titan MBL Thank's a lot for all your work, @Alex9779!
    Post by: Michael Horn, Apr 26, 2016 in forum: BigBox General Chat
  2. Michael Horn
    Post

    [Solved] BigBox reports "KILLED"

    Exp1 connector was not plugged in properly (misaligned). Thank you very much for your help, Michael
    Post by: Michael Horn, Apr 24, 2016 in forum: Calibration, Help, and Troubleshooting
  3. Michael Horn
    Thread

    [Solved] BigBox reports "KILLED"

    Hi, when I power up my BigBox the Rumba seems to start fine but after the start up screen it immediately reports "KILLED". Any idea what the cause...
    Thread by: Michael Horn, Apr 24, 2016, 4 replies, in forum: Calibration, Help, and Troubleshooting
  4. Michael Horn
    Post

    Trouble to slice BB parts with S3D

    Thank's a lot, this solved my problem. However, I think it is a bug in S3D, other slicers do slice the parts without any problem. Best regards,...
    Post by: Michael Horn, Mar 5, 2016 in forum: Calibration, Help, and Troubleshooting
  5. Michael Horn
    Post

    Trouble to slice BB parts with S3D

    Thank you very much, I will try this tomorrow.
    Post by: Michael Horn, Mar 2, 2016 in forum: Calibration, Help, and Troubleshooting
  6. Michael Horn
    Post

    Trouble to slice BB parts with S3D

    My current printer in combination with my favourite filament (PETG) is quite a bit sensitive to the first layer hight. Small deviations from the...
    Post by: Michael Horn, Mar 2, 2016 in forum: Calibration, Help, and Troubleshooting
  7. Michael Horn
    Thread

    Trouble to slice BB parts with S3D

    Hi, I am having trouble to slice and print several of the BB parts. Especially those with a 0.5mm chamfer at the bottom are always missing layer 3...
    Thread by: Michael Horn, Mar 2, 2016, 7 replies, in forum: Calibration, Help, and Troubleshooting
Showing results 1 to 7 of 7
Search Again