Separate names with a comma.
Been there, done that. I haven't destroyed my TC bed yet, but I ripped a good chunk out of a Rostock v2 bed once upon a time. I've got flex...
What is the general idea here? Simplifying wiring? Higher timing precision between x/y steppers and extruder stepper? Are there any demo...
I don't have a single prime station. I'm mounting a silicone basting brush under each tool dock, and working on my 'tpost' gcode to scrub, the...
This is why I use prime pillars, they can be very close (in time and distance) to the print. Still working on my prime/ooze management (putting...
I currently mount my spools on the table behind the printer (on rollers). They feed directly up to the Hemera Bowden (no PTFE tube before the...
One off the wall thought: That metal strip would make a nice conductor! Use it as ground for the heating element and save one pin! (just...
No problem. The only reason I noticed is because I happen to have two Hemeras: one mounted as a direct drive, one mounted as a bowden (custom...
Cool design, thanks for posting it! Just a terminology question: are you really using a bowden tube her? Or is this a clean path for a PTFE...
Is that a cost saving measure, or are there parts of the BMG that should be reprinted for weight/area? Since I haven’t used a BMG before, I’m...
Two mosquitos (+24v fans) and two BMGs on order. Any obvious bits and pieces needed that aren’t included (other than cooling fan)?
I've got some washers on there as well, but it is finicky getting them on there. I need to take some m4 washers to the metal bandsaw and cut them...
As I get used to the toolchanger, I realize I want to go vertical, and I'm looking for any advice or experience. I've currently got a bowden...
I find that front to back the bed is quite level for me. Side to side, not so much. The way the cantilever is attached to the z-mechanism is...
I haven't dialed in PLA yet, but I had a fresh roll of Prusament PETG around, so I started testing my direct-drive Hemera. I printed a cube, then...
It’s been a *long* while since college physics, but I think each magnet is generating a certain “strength” of magnetic field, looping around from...
Thanks, Garethky. I want to try a mosquito. Even though v6 works great, I’m tired of them! Been doing them for years, but the pain of getting...
One note here: The build instructions say to have the big m6 grub screw in the tool "flush with the surface"...
I’ve got a bowden-Hemera/v6-tool and a direct-drive Hemera mounted and working fine, although I need to work on bed adhesion and temps/part...
Following closely, ready to build another extruder or two. Thanks for the work!
Very cool. What is holding down the tool? Are you just clamping down the two side tabs on the base with those two printed pieces? Did you...
