Separate names with a comma.
The branch must set up to Hybrid Dual.
Then it writes the config changes.
Ready for a first test print.
Try to print a PPSU Filament on Bigbox Hybrid.
Needs 380 C to print.
On Original FW 1.1.0 RC6 get a MAXTEMP Error at 300 C.
So i made a copy of...
Sorry i have not seen that you attached the stl file.
The wand is only 0.4mm !
You use Siplify 3d?
For the slicer software it is to small.
Print an ABS 3mm you need more temperature.
Most ABS prints good with 250 C @ 40mm/s
At 60mm/s use 255-260 C.
With a 0.8mm nozzle 0.4mm layer...
Here it is
Have not tested it if it works.