Separate names with a comma.
Yes, ooze prevention was enabled. If I disable it, the value does not change the initial layer temp.
Setting G10 in the start gcode seems to work...
Tried it out a bit more, it turns out it sets the initial layer temp with ooze prevention subtracted. Which I assume is by design. But it isn't...
I just tried it out and it seems to work. Great job!
It seems to add two G10 commands at the start though, one just before the custom start...
Thank you! Will check it out.
Great work! Much appreciated.
Finally installed the last tool.
Setting up some leds on the tool changer
Designing a gopro extrusion mount for my webcam
Designing Raspberry Pi extrusion mount for the toolchanger.
Printing face shields
Thanks, that’s much appreciated. I’ll have a look at your updated files and see if I can figure out how to fix my profile.
Does anyone have an updated profile?
I’m using the profile from @Killercds and it works pretty great.
Unfortunately I have two issues in my...
Calibrating my tool changer