Separate names with a comma.
Great. I have not had any problem since. I was able to print an extra Rich's Bowden gear extruder for my dual hotend and full set of wade direct...
I no longer have stuck problem, see my test result in "Airtripper Extruder Skipping".
Here is my test result I tried hand feeding with pushing and pulling the filament. I found that after several push and pull, the filament will...
I have not passed 300c and the Bowden tube is about 400mm. I had just re-attached the thermistor and it's still the same issue.
The thermistor is set at #define TEMP_SENSOR_0 5. How do check the setting in the firmware? Could it be how I installed the sensor? The...
I am also having same problem. I was focusing on the Extruder and E-steps but I read in Google+ 3D Printing that you need to have cooling between...
I am using Wantai 42BYGHW811 and all parts are in ABS. I read in this forum and Google+ 3D Printing of folks having problem with PLA, and with...
I had installed both the new airtripper Bowden extruder and E3D hotend on Prusa i3 and was able to print the first cube but not beyond 30 minutes...
I am preparing for dual hotend using the Airtripper bowden extruder system. This is mounted on a Prusa i3 x-carriage including fan and auto level...
