Separate names with a comma.
Excellent advice from Old_Tafr. I'll add my 2ยข worth: if it has an acrylic frame, be especially careful not to overtighten the fasteners. And as...
Assuming you have the Raspberry Pi, which substitutes an Ethernet connector for a USB socket: simply remove the electronics cover, unplug the...
Thought I'd pass this on: If you assembled your BB as a kit, you remember what a pain in the ass the "poke grub screw through grille slots to...
Gotta love the way S3D handles support. Impressive print!
A creative approach, but if it's not repeatable it's not science. ;)
Thanks, Paul! I must have had my head up my a** (not unusual for me) not to notice the branches. My seeing eye dog spotted them... :eek:
I've been running Alex's firmware with MBL, which I downloaded as a .hex file from here: https://jenkins.alitecs.de/job/BigBox_Geek/ I'd like to...
They are quite grippy, though not as grippy as e.g. a router mat. NinjaFlex doesn't glue well to other plastics, hence the 2-part design (if you...
I wanted something cushier and less skiddish under my BB, so I whipped up these. The socket (in ABS or similar) has a beveled recess, the pad...
Thought I'd share this small discovery with my fellow BigBoxers. I clean my build plate after every print, and I've found that glue stick (I...
I can't comment on the i3's impending multi-material capability, which may or may not perform as advertised, but I can say this much: I presently...
The trouble with the 'official' .hex files is that for some reason the Single Hybrid Pro firmware doesn't have mesh bed levelling, while the Dual...
It seems we both need the same thing. After much headscratching & searching through these threads, I believe this:...
Here's a short YouTube video that shows what a difference post-processing can make: [MEDIA] Registax appears at about 5:00.
I recently turned my Dual Titan V1.1 into a single and re-flashed the firmware, but the bed-levelling routine isn't working the same. Instead of...
In case anyone else is wondering: I e-mailed BB support, and Greg replied that the dual cable will work fine.
Now that the BigBox has been pretty much abandoned by the makers, I've given up trying to get my Dual V1.1 to work as it should. If and when I...
Oh shucks, just remove the knob, hook the shaft to a drill, and run it at about 600 rpm for about 2 minutes. Don't forget to save when you're done. :D
Typical off-topic thread bloat (says me, adding to it). ;)
Learning g-code (beyond the bare rudiments) is what I sincerely hope to avoid ;). Still, the Rumba seems a bit of a clunker compared to some other...
