Separate names with a comma.
I read the picture/ text manual and the block was touching the heatsink. Turns out that was the problem. I rethreaded the parts and installed...
Yeah I tried the hairspray thing and man hot or cool still couldn't get the parts off. the UHU sticks they sell work so much better. I throw it...
I got the hairspray and everything was working great until my thermistor broke... the print failed midway... problem after a problem.. lol I'm...
Yeah, I have the springs installed and it is still not completely flat. it is off by 1-2 paper thickness on the ends of the glass. Also, I use...
Hi, Yes you are right the esteps are off. also the gap between the heatbed, has been mostly fixed. the only issue is that the center of the bed...
Hi Yeah after jamming the small threaded part into the heatsink... I tried printing and it worked! Just like you described. I was able to print...
ok. Looks like i figured out what's wrong. I did a few things. after I broke off the 0.40mm nozzle i placed a 0.35mm nozzle but also wrapped the...
sorry about that. I went ahead and fixed the link.
I cannot calibrate or bring now as not having the hotend operate at anything above 190C without turning down the fan has caused the extruder to...
i have an antec earthwatts 500. each 12V rail has 24amps going through it and a max of 480Watts on the 12V. i have tried 10ohm resistors on each...
Hi, Just so you can have a visual of what's going on. Here's an image of what it does. It lays down the first layer on the glass nice and thin,...
Hi, I'm using greg's extruder i'm assuming it's default_max_feedrate? #define DEFAULT_AXIS_STEPS_PER_UNIT {80,80,4000,841} // default steps...
Thanks for the reply. I am using 0.9.9 because of what you mentioned. Thanks again, Edwin
Thanks. I was previously using a j-head 0.35mm and now have the 0.40mm head on it with the e3dv5. When i extrude 10mm at 30mm/min at 230C i get...
I tried this and with the fan at 12V i was able to get to 195C but nothing higher than that, after hitting 195C it just goes between 194C and...
Hi I set up my reader to 200ohm which is the lowest and read between 3.6-3.8 ohms. if it's supposed to be 4 ohms then it appears to be good. Also...
Hi, I was wondering what settings to use for the e3dv5 hotend for 0.40mm 0.35mm 0.30mm and 0.25mm nozzles on a 3mm direct feed system on slic3r...
Hi, I just got my new e3v5 hotend 3mm 0.30mm. I'm excited and can't wait to use it but I'm having an issue. I can't pass 189C I updated my...
