Separate names with a comma.
Hopefully I can help with some of your questions.
1: Very. There is the caveat that it can be a little tricky to setup, which leads us...
I've never done it myself, but their documentation should be a good place to start?...
How does it wire up?
What LED is to be used?
You can solder without problems. I extend the wires all the time. Just don't make them only longer than they actually need to be.
What are you trying to connect it to? Duet?
Molex Microfit 3. It's the same connector as on most E3D products.
The most common issue with failed tool pick-ups and dropped tool is bad alignment.
Check the alignment, check the position of the tool in...
Larger nozzles make some good prints, and quickly too.
Did you do the design for the separator yourself?
Perhaps give M556 a check?
eBay. Get a 4mm (ideal), 2mm (if no 4mm), 8mm (if no 2/4) pitch ~400mm length NEMA17 integrated leadscrew motor. It will need to be cut down to...
I think that is a duet 3 pin output, not a duet 2 pin.
My thoughts. Fix the dock positions and tool alignments.
You don't move your garage back a bit because you keep parking the car too close to the...
It's mesh bed compensation not being able to keep up with fast travel moves.
Use G29 S2 at the start of any scripts, and G29 S1 at the end when...
It is with the heaviest of hearts that E3D are announcing the death of one of our founding directors, Sanjay Mortimer. He passed away on Saturday...
Most likely, yes.
Hi Bob, I hope you're enjoying the machine :)
The Hemera Revo tools will technically be the same as the current Hemera V6, with the only...
That would work if the parts were modified / redesigned.
There's nothing to say it would be any more reliable though. You still don't know for...
Google is your friend.
This should get you started though...
This might be of help | https://wiki.e3d-online.com/BigBox_Build_Manual